Honda Passport Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
31 Posts
Discussion Starter · #1 ·
OK, got my set of crossbars from the dealer and am stymied at the "remove plastic trim" in step 1! Took out the Torx screw, but I don't see any obvious place to pry up and release a tab or two. I know the rear section slides back and then up, but anyone have any specific input to help me get started? As you can imagine, I'm not eager to break/gouge/mar anything on my new PP Elite!
 

·
Registered
Joined
·
276 Posts
I was able to pop the cover off with a thin flat head screwdriver. Takes a bit of force. There are 2 posts. One comes out with wedging the screwdriver in at the end and lifting up. Then sliding the cover toward the back to the vehicle. No damage thankfully.
 
  • Like
Reactions: Mezzfin

·
Registered
Joined
·
36 Posts
OK, got my set of crossbars from the dealer and am stymied at the "remove plastic trim" in step 1! Took out the Torx screw, but I don't see any obvious place to pry up and release a tab or two. I know the rear section slides back and then up, but anyone have any specific input to help me get started? As you can imagine, I'm not eager to break/gouge/mar anything on my new PP Elite!
The installation cost of the Honda crossbars was $40. I didn't think the hassle of installing them by myself was worth a $40 savings since I would probably scratching or denting my roof trying to install them myself. Considering the cost of an Elite, the additional $40 is a pittance.
 
1 - 6 of 6 Posts
Top