Honda Passport Forum banner
1 - 11 of 11 Posts

· Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
So after owning my PP for 3 months now I've come to the conclusion I hate my horn lmao. I know some of the guys here have swapped out the factory one for something different...but it's been cold here in NY and I haven't had a chance to go digging yet so I humbly ask: where the heck is the horn located on this thing? I'm assuming it's gonna be hidden somewhere but if someone could point me in the right direction it would be greatly appreciated!

Bonus kudos from me if someone has a walkthrough to gain access to it! :)
 

· Registered
Joined
·
235 Posts
No need to remove the front bumper.

Start by unclipping the upper radiator support cover
Arm Sleeve Bag Automotive exterior Rectangle


Passenger side:
Locate the coolant overflow tank on left side of radiator. It is the white bottle with a black hose that goes to the fitting under the radiator cap.
Look directly in the space between the overflow tank and the front grill.
You can see the horn there. Removing the overflow tank gives you access to the mounting bolt and wire connection.

Driver Side:
Remove the snorkel air intake resonator, that goes from grille to air box.
Look directly in the space that was under that resonator, between the battery and the front grille.
You can see the horn there. However, VERY difficult to access this space until you disconnect and remove the battery.
 

· Registered
Joined
·
1 Posts
I think you should contact the service center. My right horn stopped working one month ago. The second one broke down after a while. This is a typical breakdown in my type of car. Therefore I turned to https://hornblasters.com. Btw, you can find a lot of information about your problem on the Internet. In my case, I had to remove the bumper. It was necessary to take out the right-wing and slightly adjust the radiator grille. The work took about half a day.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top