Honda Passport Forum banner
1 - 13 of 13 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello all,

Just picked up the 2020 Passport Elite last Wednesday and loving it so far.

It came with a front license plate holder and this piece of trim that I'm not sure about. I searched for the part number 81793-TG7A, but nothing comes up. Any ideas?

Thanks in advance!
 

Attachments

· Super Moderator
2019 Passport Elite, Modern Steel (4/2019)
Joined
·
3,009 Posts
It looks very similar to a piece I found in my cargo area, I ended up finding its home as a cap on the rail/glider for the passenger seat. Maybe try that?
 

· 2019 Touring: since March-2019
Joined
·
3,863 Posts
Hello all,

Just picked up the 2020 Passport Elite last Wednesday and loving it so far.
Can't help with your jigsaw puzzle piece, it does look like something that could be around the seats or down at the floor level somewhere... But I do want to say;

Welcome & Congrats!
 

· Registered
Joined
·
1,029 Posts
My 1st guess is a seat rail end guard.
Check the front of each rear seat rail.
 

· Registered
Joined
·
61 Posts
I have the same issue. My PP came with loose two pieces of trim in the back that I'm not 100% on what they were for, I think the cargo area, but am not sure, nothing appears to be missing.
 

· 2019 Touring: since March-2019
Joined
·
3,863 Posts
I would be calling my Honda dealer and ask them if the factory was just lazy and didn't install all of the trim or if this was a part that they were supposed to install or at least tell me about.
At least they mounted the Steering Wheel...!
 
  • Like
Reactions: 2984

· Registered
Joined
·
1,029 Posts
I would be calling my Honda dealer and ask them if the factory was just lazy and didn't install all of the trim or if this was a part that they were supposed to install or at least tell me about.
Watch the 1986 movie Gung Ho, about assembly line expectations.
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top